User Guide

Part two
Design entry
Part two provides information about how to enter circuit
designs in OrCAD
®
Capture that you want to simulate.
• Chapter 3, Preparing a design for simulation, outlines the
things you need to do to successfully simulate your
schematic including troubleshooting tips for the most
frequently asked questions.
• Chapter 4, Creating and editing models, describes how to
use the tools to create and edit model definitions, and
how to configure the models for use.
• Chapter 5, Creating parts for models, explains how to
create symbols for existing or new model definitions
so you can use the models when simulating from your
schematic.
•
Chapter 6, Analog behavioral modeling, describes how to
model analog behavior mathematically or using table
lookups.
Pspug.book Page 53 Wednesday, November 11, 1998 1:14 PM