User Guide

Chapter 2 Simulation examples
24
Using the simulation output file
The simulation output file acts as an audit trail of the
simulation. This file optionally echoes the contents of the
circuit file as well as the results of the bias point
calculation. If there are any syntax errors in the netlist
declarations or simulation commands, or anomalies while
performing the calculation, PSpice writes error or
warning messages to the output file.
To view the simulation output file
1 From PSpice’s View menu, choose Output File.
Figure 5 shows the results of the bias point calculation
as written in the simulation output file.
Figure 5 Simulation output file.
2 When finished, close the window.
Pspug.book Page 24 Wednesday, November 11, 1998 1:14 PM