User Guide

Chapter 2 Simulation examples
20
To assign names (labels) to the off-page connectors
Label the off-page connectors as shown in Figure 2 on
page 2-16.
1 Double-click the name of an off-page connector to
display the Display Properties dialog box.
2 In the Name text box, type the new name.
3 Click OK.
4 Select and relocate the new name as desired.
To assign names to the parts
1 Double-click the second VDC part to display the Parts
spreadsheet.
2 Click in the first cell under the Reference column.
3 Type in the new name Vin.
4 Click Apply to update the changes to the part, then
close the spreadsheet.
5 Continue naming the remaining parts until your
schematic looks like Figure 2 on page 2-16.
To change the values of the parts
1 Double-click the voltage label (0V) on V1 to display
the Display Properties dialog box.
2 In the Value text box, type
5V.
3 Click OK.
4 Continue changing the Part Value properties of the
parts until all the parts are defined as in Figure 2 on
page 2-16.
Your schematic page should now have the same parts,
wiring, labels, and properties as Figure 2 on page 2-16.
To save your design
1 From the File menu, choose Save.
A more efficient way to change the
names, values and other properties of
several parts in your design is to use the
Property Editor, as follows:
1 Select all of the parts to be modified
by pressing C and clicking each
part.
2 From the Edit menu, choose
Properties.
The Parts Spreadsheet appears.
Change the entries in as many of the
cells as needed, and then click Apply to
update all of the changes at once.
pre
Pspug.book Page 20 Wednesday, November 11, 1998 1:14 PM