User Guide

Chapter 2 Simulation examples
18
To move the text associated with the diodes (or any other object)
1 Click the text to select it, then drag the text to a new
location.
To place the other parts
1 From the Place menu, choose Part to display the Place
Part dialog box.
2 Add the library for the parts you need to place:
a Click the Add Library button.
b Select ANALOG.OLB (from the PSpice library)
and click Open.
3 Follow similar steps as described for the diodes to
place the parts listed below, according to Figure 2. The
part names you need to type in the Part name text box
of the Place Part dialog box are shown in parentheses:
• resistors (R)
• capacitor (C)
4 To place the off-page connector parts
(OFFPAGELEFT-R), click the Place Off-Page
Connector button on the tool palette.
5 Add the library for the parts you need to place:
a Click the Add Library button.
b Select CAPSYM.OLB (from the Capture library)
and click Open.
6 Place the off-page connector parts according to
Figure 2.
7 To place the ground parts (0), click the GND button on
the tool palette.
8 Add the library for the parts you need to place:
a Click the Add Library button.
b Select SOURCE.OLB (from the PSpice library) and
click Open.
9 Place the ground parts according to Figure 2.
pre
Pspug.book Page 18 Wednesday, November 11, 1998 1:14 PM