User Guide

Example circuit creation
17
2 From the Place menu, choose Part to display the Place
Part dialog box.
3 Add the library for the parts you need to place:
a Click the Add Library button.
b Select SOURCE.OLB (from the PSpice library) and
click Open.
4 In the Part text box, type
VDC.
5 Click OK.
6 Move the pointer to the correct position on the
schematic page (see Figure 2) and click to place the
first part.
7 Move the cursor and click again to place the second
part.
8 Right-click and choose End Mode to stop placing
parts.
To place the diodes
1 From the Place menu, choose Part to display the Place
Part dialog box.
2 Add the library for the parts you need to place:
a Click the Add Library button.
b Select DIODE.OLB (from the PSpice library) and
click Open.
3 In the Part text box, type
D1N39 to display a list of
diodes.
4 Select D1N3940 and click OK.
5 Press r to rotate the diode to the correct orientation.
6 Click to place the first diode (D1), then click to place
the second diode (D2).
7 Right-click and choose End Mode to stop placing
parts.
or
Note There are two sets of library files
supplied with Capture and PSpice. The
standard schematic part libraries are found
in the directory Capture\Library. The part
libraries that are designed for simulation
with PSpice are found in the sub-directory
Capture\Library\PSpice. In order to have
access to specific parts, you must first
configure the library in Capture using the
Add Library function.
or
W
h
en p
l
acing parts:
•
Leave space to connect the parts with
wires.
•
You will change part names and values
that do not match those shown in
Figure 2 later in this section.
Pspug.book Page 17 Wednesday, November 11, 1998 1:14 PM