User Guide

Analog example
343
Displaying voltages on nets
After selected an analysis, voltages on nets and currents
into device pins can be displayed in the Probe windows
using either schematic markers or output variables (as
will be demonstrated in this example).
To display the voltages at the OUT1 and OUT2 nets using output
variables
1 From the Trace menu, choose Add Trace to display the
Add Traces dialog box.
The Simulation Output Variables frame displays a list
of valid output variables.
2 Click V(OUT1) and V(OUT2), then click OK. The
Probe window should look similar to Figure 96.
press UI
Pspug.book Page 343 Wednesday, November 11, 1998 1:14 PM