User Guide

Chapter 13 Analyzing waveforms
342
\PSPICE\SAMPLES\ANASIM\EXAMPLE\
EXAMPLE.OPJ
3 From the PSpice menu, choose Run to start the
simulation.
PSpice generates a binary waveform data file containing
the results of the simulation. A new Probe window
appears with the waveform data file EXAMPLE.DAT
already loaded (Figure 96).
Because this sample project was set up as a transient
analysis type, the data currently loaded are the results of
the transient analysis.
Note
In this sample, the voltage markers for OUT1 and OUT2 are already
placed in the design. If the markers are not placed prior to
simulating, you can display the waveforms later, as explained
below in
Displaying voltages on nets
.
I
f
PSpice is set to s
h
ow traces
f
or a
ll
markers on startup, you will see the
V(OUT1) and V(OUT2) traces when the
Probe window displays. To clear these
traces from the plot, from the Trace menu,
choose Delete All Traces.
Figure 96 Waveform display for EXAMPLE.DAT.
Pspug.book Page 342 Wednesday, November 11, 1998 1:14 PM