User Guide

Chapter 13 Analyzing waveforms
332
2 Point to the wires or pins you wish to mark and click
to place the chosen markers.
3 Right-click and select End Mode to stop placing
markers.
4 If you have not simulated the circuit yet, from the
PSpice menu, choose Run.
To hide or delete marked results
1 From Capture’s PSpice menu, point to Markers, then
choose one of the following:
Table 5
Waveform Markers menu command Advanced submenu command
voltage Voltage Level not required
voltage
differential
Voltage Differential not required
current Current Into Pin not required
digital signal Voltage Level not required
dB*
* You can use these markers instead of the built-in functions provided in
output variable expressions (see
Table 12 on page 13-364
).
However, these markers are only available after defining a simulation
profile for an AC Sweep/Noise analysis.
Advanced db Magnitude of Voltage
db Magnitude of Current
phase* Advanced Phase of Voltage
Phase of Current
group delay* Advanced Group Delay of Voltage
Group Delay of Current
real* Advanced Real Part of Voltage
Real Part of Current
imaginary* Advanced Imaginary Part of Voltage
Imaginary Part of Current
T
h
e co
l
or o
f
t
h
e mar
k
er is t
h
e same as its
corresponding waveform analysis trace. If
you change the color of the trace, the color
of the marker changes accordingly.
Pspug.book Page 332 Wednesday, November 11, 1998 1:14 PM