User Guide

Viewing waveforms
331
3 Do one of the following:
• From the Simulation menu, choose Run to resume
the simulation.
• From the Simulation menu, choose Stop to stop the
simulation.
Using schematic page markers to add traces
You can place markers on a schematic page to identify the
points where you want to see waveform results displayed.
You can place markers:
• Before simulation, to limit results written to the
waveform data file and automatically display those
traces in PSpice.
• During or after simulation, with PSpice running, to
automatically display traces in the active Probe
window.
The color of the marker you place is the same as its
corresponding waveform analysis trace. If you change the
color of the trace, the color of the marker on the schematic
page changes accordingly.
The Markers submenu also provides options for
controlling the display of marked results in PSpice, after
initial marker placement, and during or after simulation.
To place markers on a schematic page
1 From Capture’s PSpice menu, point to Markers, then
choose the marker type you want to place. (Some of
the markers are from the Advanced submenu.)
See Trace expressions on
page 13-356 for ways to add traces
within PSpice.
Pspug.book Page 331 Wednesday, November 11, 1998 1:14 PM