User Guide

Viewing waveforms
327
Viewing waveforms
If you are using Capture, you can either view waveforms
automatically after you run a simulation, or you can
monitor the progress of the simulation as it is running.
Setting up waveform display from Capture
You can configure the way you want to view the
waveforms in PSpice by defining display settings in the
Probe Window tab in the Simulation Settings dialog box.
The display settings in the Probe Window tab are
explained in the following table.
You
d
o not nee
d
to exit PSpice i
f
you are
finished examining the simulation results
for one circuit and want to begin a new
simulation from within Capture. However,
PSpice unloads the old waveform data file
for a circuit each time that you run a new
simulation of the circuit. After the
simulation is complete, the new or updated
waveform data file is loaded for viewing.
Pspug.book Page 327 Wednesday, November 11, 1998 1:14 PM