User Guide

Chapter 12 Monte Carlo and sensitivity/worst-case analyses
300
To set up the Monte Carlo analysis
1 Select the Monte Carlo/Worst Case option.
2 Check Monte Carlo if it is not already selected.
3 In the Number of runs text box, type 10.
4 In the Save data from list box, select All.
5 Type I(Meter) in the Output variable text box.
6 Click OK to save the simulation profile.
Running the analysis and viewing the results
To complete setup, simulate, and view results
1 From Capture’s PSpice menu, choose Run to start the
simulation
When the simulation is complete, PSpice
automatically displays the selected waveform.
Because PSpice ran a Monte Carlo analysis, it saved
multiple runs or sections of data. These are listed in
the Available Sections dialog box.
2 From PSpice’s Trace menu, choose Performance
Analysis.
3 Click the Select sections button.
4 In the Available Sections dialog box, click the All
button.
5 Click OK.
Table 3
In this text box... Type this...
Parameter name
P
Start value
0
End value
5.0
Increment
0.1
Pspug.book Page 300 Wednesday, November 11, 1998 1:14 PM