User Guide

Monte Carlo analysis
299
Setting up the analyses
This section shows how to define and enable a DC
analysis that sweeps the pressure value and a Monte Carlo
analysis that runs the DC sweep with each change to the
resistance multipliers.
To set up the DC sweep
1 In the PSpice menu, choose New Simulation Profile or
Edit Simulation Settings. (If this is a new simulation,
enter the name of the profile and click OK.)
The Simulation Settings dialog box appears.
2 Select DC Sweep in the Analysis type list box.
3 In the Sweep Variable frame, select Global Parameter.
4 Enter the following values:
See Setting up analyses on
page 7-197 for a description of the
Simulation Settings dialog box.
Figure 80 Pressure sensor circuit with RMonte1 and RTherm
model definitions.
Pspug.book Page 299 Wednesday, November 11, 1998 1:14 PM