User Guide

Monte Carlo analysis
295
4 Click the Display button.
5 In the Display Format frame, choose the Value Only
option to make the DC value (
1.35v) visible on the
schematic.
6 Click OK, then click Apply to apply the changes you
have made to the part.
7 Close the Parts Spreadsheet.
Setting up the parameters
To complete the value specification for R3, define the
global parameters Pcoeff, P, and Pnom.
To define and initialize Pcoeff, P, and Pnom
1 Place a PARAM part on the schematic page.
2 Double-click the PARAM part to display the Parts
Spreadsheet.
3 For each parameter, create a new property by clicking
New and typing its name. Enter its corresponding
value by clicking in the cell under the new property
name and typing its value. Specify the parameter
name and corresponding value as follows.
4 Click Apply to save the changes you have made then
close the Parts Spreadsheet.
Table 2
Property Value
Pcoeff -0.06
P0
Pnom 1.0
Pspug.book Page 295 Wednesday, November 11, 1998 1:14 PM