User Guide

Noise analysis
243
Setting up a noise analysis
To set up the noise analysis
1 From the PSpice menu, choose New Simulation
Profile or Edit Simulation Settings. (If this is a new
simulation, enter the name of the profile and click
OK.)
The Simulation Settings dialog box appears.
2 Choose AC Sweep/Noise in the Analysis type list box.
3 Under Options, select General Settings if it is not
already enabled.
4 Specify the AC sweep analysis parameters as
described on page 9-235
.
5 Enable the Noise Analysis check box.
6 Enter the noise analysis parameters as follows:
Pspug.book Page 243 Wednesday, November 11, 1998 1:14 PM