User Guide

Chapter 8 DC analyses
228
DC sensitivity
Minimum requirements to run a DC sensitivity
analysis
Minimum circuit design requirements
None.
Minimum program setup requirements
1 In the Bias Point dialog box, select Perform Sensitivity
analysis (.SENS).
2 Enter the required value(s) in the Output variable(s)
box.
3 Click OK to save the simulation profile. (Be sure you
give the new profile an appropriate name under the
General tab prior to saving.)
4 In Capture, from the PSpice menu, select Run to start
the simulation.
Pspug.book Page 228 Wednesday, November 11, 1998 1:14 PM