User Guide

Bias point
223
Bias point
Minimum requirements to run a bias point analysis
Minimum circuit design requirements
None.
Minimum program setup requirements
1 Under Analysis type in the Simulation Settings dialog
box, select Bias Point.
2 For the General Settings option, enter the necessary
parameter values and select the appropriate check
boxes to complete the analysis specifications.
3 Click OK to save the simulation profile.
4 In Capture, from the PSpice menu, select Run to start
the simulation.
Overview of bias point
The bias point is calculated for any analysis whether or
not the Bias Point analysis is enabled in the Simulation
Settings dialog box. However, additional information is
reported when the Bias Point analysis is enabled.
When Bias Point analysis is not enabled, only analog node
voltages and states are reported to the output file.
A
l
so see Save and load bias point
on page A-374
.
Pspug.book Page 223 Wednesday, November 11, 1998 1:14 PM