User Guide

DC Sweep
219
5 Click OK twice to exit the dialog boxes.
Nested DC sweeps
A second sweep variable can be selected after a primary
sweep value has been specified in the DC Sweep dialog
box. When you specify a secondary sweep variable, it
forms the outer loop for the analysis. That is, for every
increment of the second sweep variable, the first sweep
variable is stepped through its entire range of values.
To set up a nested sweep
1 Under Options, select the Secondary Sweep box for
the DC Sweep Analysis type.
Table 12
Set this attribute... To this value...
DC
DC_level
where
DC_level
is in volts or amps
(units are optional).
Pspug.book Page 219 Wednesday, November 11, 1998 1:14 PM