User Guide

DC Sweep
215
Minimum program setup requirements
1 In Capture, select New Simulation Profile or Edit
Simulation Settings from the PSpice menu. (If this is a
new simulation, enter the name of the profile and click
OK.)
The Simulation Settings dialog box appears.
2 Under Analysis type, select DC Sweep.
3 For the Primary Sweep option, enter the necessary
parameter values and select the appropriate check
boxes to complete the analysis specifications.
4 Click OK to save the simulation profile.
5 Select Run under the PSpice menu to start the
simulation.
Note
Do not specify a DC sweep and a parametric analysis for the same
variable.
Pspug.book Page 215 Wednesday, November 11, 1998 1:14 PM