User Guide

Part three
Setting Up and Running
Analyses
Part Three describes how to set up and run analyses and
provides setup information specific to each analysis type.
• Chapter 7, Setting up analyses and starting simulation,
explains the procedures general to all analysis types to
set up and start the simulation.
• Chapter 8, DC analyses, describes how to set up DC
analyses, including DC sweep, bias point detail, small-
signal DC transfer, and DC sensitivity.
•
Chapter 9, AC analyses, describes how to set up AC
sweep and noise analyses.
•
Chapter 10, Transient analysis, describes how to set up
transient analysis and optionally Fourier components.
This chapter also explains how to use the Stimulus
Editor to create time-based input.
•
Chapter 11, Parametric and temperature analysis,
describes how to set up parametric and temperature
analyses, and how to run post-simulation
performance analysis in Probe on the results of these
analyses.
Pspug.book Page 193 Wednesday, November 11, 1998 1:14 PM