User Guide

Defining part properties needed for simulation
145
Now suppose that the part definition shows four pins:
IN+ OUT+ IN- OU
T-
The number of pins on the part equals the number of
nodes in the subcircuit definition.
If the correspondence between pin names and nodes is as
follows:
then the template looks like this:
X^@REFDES %IN+ %IN- %OUT+ %OUT- @MODEL
The rules of agreement are outlined in Figure 34.
Table 6
This node name... Corresponds to this pin name...
10 IN+
3 IN-
27 OUT+
2OUT-
Pspug.book Page 145 Wednesday, November 11, 1998 1:14 PM