User Guide

Creating parts for models
5
Chapter overview
This chapter provides information about creating parts for
model definitions, so you can simulate the model from
your design using OrCAD Capture.
Topics are grouped into four areas introduced later in this
overview. If you want to find out quickly which tools to
use to complete a given task and how to start, then:
1 Go to the roadmap in Ways to create parts for models
on
page 5-129.
2 Find the task you want to complete.
3 Go to the sections referenced for that task for more
information about how to proceed.
For genera
l
in
f
ormation a
b
out creating
parts, refer to the OrCAD Capture
User’s Guide.
Pspug.book Page 127 Wednesday, November 11, 1998 1:14 PM