Owners manual

6. Using the included plastic tie, attach the Safety
Placard (8) to the frame near the point where
jumpers will climb onto and off the trampoline.
The trampoline is now fully assembled. Make
sure that all parts are securely attached.
Familiarize yourself and all users of the tram-
poline with the safety precautions, use and
instructional materials, and care and mainte-
nance instructions in this manual before using
the trampoline.
Loosen the straps (not shown) on the underside of
the frame pad (for clarity, the frame pad is not shown
in the steps 8 and 11). Do not remove the frame pad
from the trampoline.
See the inset drawing.
6
Frame
8. Lay a Bottom enclosure pole(13) and a
Top enclosure pole(14) with Plastic Cap on the
ground.
Make sure that the Bottom enclosure pole(13) is
oriented
so the small holes are in the position shown.
Slide a Foam Sleeve(18) onto each of the tubes;
note that the ends of the bottom enclosure pole(13)
should not be covered.
Insert the Bottom enclosure pole(13) into the Top
enclosure pole(14).
Tighten a Self-tapping Screw (9) into the small hole
in the Tube (13,14).
Assemble the remaining Bottom enclosure pole(13),
Top enclosure pole(14), and Foam sleeves(18) in the
same way.


9.
Tighten Self-tapping Screw
Into Small Hole
Small Hole
Plastic Cap
(16)












18





Plastic Cap
(16)
U-bolts
T-connector

10
11
10
11
12
7.

10
10
12
20
12
3
14

Slide a ‘WEDGE’(20) onto the Bottom enclosure
pole(13), the top of the ‘Wedge’(20) should touch
the bottom of the T-Connector(2), and that the
bottom of the ‘Wedge’ (20) should be even with the
bottom of the Bottom enclosure pole.
Slide one of the U-bolts(12) up until it touches the
bottom of the T-connector(2), and tighten the two
Locknuts(10) on the U-bolt. Slide the other U-bolt
up until it is 2” above the lower end of the Straight
tube,and tighten the two Locknuts on the U-bolt.
Then, press two U-bolt Plastic Caps(21)
onto each U-bolt.
3

21
21
12
11
10
21
T-connector
11
10
12
11
10
12