Quick Start Guide

Rain Delay
Rain delay allows you to postpone watering for a set
period of time. To access the rain delay, follow the steps
below.
1. With the timer in the AUTO/MANUAL mode, press
and hold the dial for 3 seconds.
2. The rain delay symbol will appear and the number of
days will begin to flash.
3. Turn the dial until the desired number of days is
displayed, then press to confirm. You may select a delay
of 12 hours, 24 hours, or from 2 to 7 days.
4. Screen will flash between clock and remaining time
before programmed cycle resumes.
Manual/Hand Watering
This feature allows you to water without interrupting
your set schedule. To access this feature, follow the
steps below.
1. With the arrow pointing to AUTO/MANUAL, press the
FCC Statement: FCC ID: ML6-HT34BT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC Warning: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device meets the FCC and IC requirements for RF exposure in
public or controlled environments. The end user is advised to maintain a
distance 20 cm from the timer and any personnel to ensure compliance
with RF exposure regulations.
IC Statement: IC: 3330A-HT34BT
This device complies with Industry Canada license exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation. This Class B digital apparatus complies with Canadian ICES-
003.
Remarque: cet appareil été testé et déclaré conforme aux limites
d’exposition pour les appareils numériques de classe B, selon la section
15 de la Règlementation de la FCC. Ces limites sont conçus pour fournir
une protection raisonnable contre les interférences nuisibles dans une
installation résidentielle. Cet appareil produit, utilise et peut émettre
de l’énergie radio fréquence et, si elle n’est pas installée et utilisée
conformément aux instructions, peut causer des interférences nuisibles
aux communications radio. Cependant, il n’est pas garantie que des
interférences ne se produisent pas dans une installation particulière. Si cet
appareil cause des interférences gênantes à la réception d’un signal radio
ou de télévision, ce qui peut être déterminé en allumant et en éteignant
l’appareil, l’utilisateur peut corriger les interférences en suivants une des
mesures suivantes :
• Réorientez ou repositionnez l’antenne de réception.
• Augmentez la distance entre l’appareil et le récepteur.
• Branchez l’appareil dans une prise sur un circuit différent du circuit
sur lequel le récepteur est branché.
• Consulter le revendeur ou un technicien radio/TV expérimenté
pour obtenirde l’aide.
Cet appareil est conforme aux exigences de la FCC et de l’IC
concernant l’exposition aux ondes dans un environnement public ou
contrôlé. Il est conseillé à l’utilisateur final de maintenir une distance
de 20 cm du contrôleur pour assurer la conformité aux réglementations
d’exposition RF.
Information de conformité pour le Canada Déclaration de l’IC :
Cet appareil est conforme à la norme RSS d’Industry Canada. Son
fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil
ne doit pas causer d’interférences nuisibles, et (2) cet appareil doit
tolérer toutes les interférences, dont les interférences pouvant causer
un fonctionnementnon désiré. Cet appareil numérique de classe B est
conforme à la norme canadienneICES-003.
PN 24634-24 rA
Need Help?
If you encounter a problem, please use the following
resources before retuning your B-hyve to the store.
Scan the QR Code to access the help page online.
[e-mail]
email us
call us
1-801-299-5555
text us
801-905-8260
ADDITIONAL FEATURES
dial to select.
2. Manual will appear and minutes will begin to flash.
Zone [1] is automatically seleceted, press ZONE button if
you want to manually water from Zone [2]
3. Turn the dial until the desired number of
minutes are displayed. Select between 1 to 360 minutes
then press dial to confirm.
4. The manual icon will appear and the screen will flash
between clock and time remaining before programmed
cycle resumes.
Note: There may be a slight delay between the time the
dial is pressed and when watering begins.
Timer
Range: 150 ft without interference
Pressure Operating Range: 10-100 PSI
Temperature Operating Range:
35°F-122°F (2-50°C)
For Outdoor Use With Cold Water Only
Not For Use With Appliances
To stop manual watering press the dial. The manual
watering symbol will turn off and your timer will
resume its programmed watering schedule.
If the manual watering runs into the next scheduled
event, the next watering event is canceled--manual
watering takes priority.
To remove a rain delay, press and hold the
dial for 3 seconds. The rain delay symbol
will turn off and your timer will resume its
programmed watering schedule.
Purchase the B-hyve Wi-Fi Hub
online or at your local retailer
PN # 21027
You are here
A B-hyve Wi-Fi Hub connection
gives you control from anywhere