User's Manual

Orbit Irrigation Products

Date:

3/12/20202014/6/

General Specification GS-8396

Rev: 0

Figure 1 - Battery Tray Design Guideline

4.1.3 PCB conformal coating with UV tracers required

4.1.4 Output Driving Solenoid Pulse

4.1.4.1 Operating Voltage: 19.9 V

4.1.4.2 Pulse Duration: 12mS minimum

4.1.4.3 Behavior: A reinforcement pulse is required when turning the valve

off

4.2 General Firmware Requirements

4.2.1 Fast Clock Mode – Device must be able to operate in “fast mode” to allow for

accelerated testing (real-time 1min = 1 hour)

4.2.2 Fast clock mode must be initiated using a button configuration (non-

compromising of IP rating)

4.2.3 Firmware version will be displayed on powerup during fast clock mode. It will

remain visible for 2 seconds.

5 MECHANICAL

5.1 General Workmanship Standard

5.1.1 All units being tested must meet requirements per section 6.4 of QA-60

5.2 Threads

5.2.1 All GHT and BSP threads must meet standard (tested with appropriate go

and nogo thread gauge)

5.2.2 Threaded inlet connection will be a brass swivel with TPR overmold

5.3 Environmental Requirements

5.3.1 Maximum operating humidity: 90% RH at 100°F for 24 hours

5.3.2 Operating Temperature: 0°C to 70°C (32°F to 158°F)

5.3.3 Storage temperature: -20°C to 80°C (-4°F to 176°F)