Instructions / Assembly

ManualsBrandsOrbit ManualsHeating, Ventilation, and Air ConditioningPerformance PVC 1/2 in. Mist System

Mist System Operation and Maintenance

The following recommendations will assist you in maintaining your mist nozzles and prevent-

ing unnecessary clogging.

Draining Water from Mist Line - Whenever the mist system is not in use the residual water

should be drained to minimize nozzle clogging. If your system has had a(n) Auto Drain

Valve(s) installed correctly at the lowest points in the system, no additional steps are

required after turning off the system. If an Auto Drain Valve has not been installed, detach

the system at the water source and allow the water to drain completely.

Nozzle Cleaner (Model 10103)- Periodically clean the nozzles in the system. See bottle for

instructions.

Calcium Inhibitor Filter (Model 10109)- A Calcium Inhibitor Filter should be used to prevent

any solid sediments from passing from water source to nozzles.

Flushing System - Always remove nozzles at the end of the summer season. Before rein-

stalling your nozzles the following year, flush the system for 5 minutes. To keep the mist line

free from debris in the off season, install Orbit

|Arizona Mist

Nozzle Plugs (Model 10107H)

in place of the nozzle. You should also flush the system if it has been idle for longer than a

month.

For questions or comments, please contact Orbit

Customer Service at Orbit Irrigation

Products, Bountiful, UT 84011 or by calling at (800) 488-6156.

System Expansion/Accessories

The 1/2 in. Misting System can be easily expanded from the original kit of 5 nozzles/10 ft. of

mist line to 125 nozzles/250 feet (dependent upon your local water pressure available) by add-

ing additional split sections and sections of 1/2 in. paintable UV-treated PVC pipe. Additional

PVC pipe and fittings can be found at your local retail store centers for a nominal cost. Listed

below are the accessories available to expand and/or maintain your 1/2 in. Misting System for

many years of cool mist enjoyment.

Orbit

Arizona Mist

Accessories

Warranty and Statement

Orbit

Irrigation Products, Inc. warrants to its customers that its Orbit

|Arizona Mist

products will be free from defects in materials and workmanship for a period of four years

from the date of purchase. We will replace, free of charge, the defective part or parts found

to be defective under normal use and service for a period of up to four years after purchase

(proof of purchase required). We reserve the right to inspect the defective part prior to

replacement. Orbit

Irrigation Products, Inc. will not be responsible for consequential or

incidental cost or damage caused by the product failure. Orbit

liability under this warranty

is limited solely to the replacement or repair of defective parts.

To exercise your warranty, return the unit to your dealer with a copy of the sales receipt.

Questions please call: 1-800-488-6156 or 1-801-299-5555

www.orbitonline.com

Problem Solution

1. If the leak is occurring at the union between the split section

and PVC pipe section, a water tight seal was not formed when

cemented. This occurs if cement was not applied completely

around the inside of the split section and the outside of the pipe

section or if water was run prematurely through the mist line

before a watertight seal could be established. The split section

must be removed and replaced or cemented again.

TroubleShooting

Leak at Split

Section

1. Make sure the nozzle is sufficiently tightened into place. HAND

TIGHTEN ONLY DO NOT USE TOOLS.

2. Check to make sure the nozzle O-ring is in place.

3. Nozzle may be clogged which can give the appearance of

“leaking” or dripping. Clean with nozzle cleaner (See use

instructions on nozzle cleaner bottle) and/or remove debris left

from inadequate flushing of mist line by blowing out with air. Do

not attempt to clean by sticking foreign object into nozzle

opening–this will result in nozzle damage.

Leak at Nozzle

Picture Part # Product Description

10107

10109

10103

10106

10112

10056

Plug - Use to close off unneeded misting outlets

Calcium Inhibitor Filter - Attaches directly to 3/4

in. hose faucet. Protects nozzles from clogging

due to sediment or calcium build up

Nozzle Cleaner - 8 oz. bottle. Used to dissolve

mineral deposits on nozzles

Mist Nozzle (5 Pack) - Brass and stainless steel

nozzles available as replacements

Split Section - PVC Couplings with nozzles

are available to expand your mist system in

5 packs

4 in. Nozzle Extension - Use to extend nozzle

away from Split Section and allow for easy,

versatile direction of mist

Orbit® Irrigation Products Inc.

845 N. Overland Rd.

North Salt Lake, Utah 84054 USA

http://www.orbitonline.com

800-488-6156

801-299-5555

P/N 16055-24 Rev C