Welcome to SMART WIFI SPRINKLER TIMER Quick Start Guide
Contents in the Box A WiFi Sprinkler Timer D Keys B Screwdriver E Quick Start Guide C Installation Hardware A *Plug varies by country B C D E
The B-hyve™ App Install the B-hyve™ app on your smart device You will need a smart device to connect the timer to Wi-Fi. After the timer is paired, you can also use a computer to adjust your timer. Timer Connected Symbol Note: There is a wizard in the app to guide you through initial set up of your sprinkler timer. In addition, there are help icons throughout the app with more information and useful tips. Weather/Temp.
Timer Installation Select a location Choose a location near power and away from direct sunlight, if possible. Make sure to leave room for the timer door to open completely. This location should also have a good Wi-Fi signal. You can check this using a smart phone. (Find a location that has a minimum of two bars) Minimum Signal Note: If replacing a timer, it is helpful to take a photo of the wires before you remove them from the old timer. Mount the timer Install a screw (included) into the wall.
Connect Valve Wires Prepare wire Strip 1/2" (13 mm) of insulation from each wire. Connect wires Attach one wire from each valve to a “Common” (COM) wire and the other wires to a numbered terminal (only one wire per terminal.
Timer Installation–Connecting to Wi-Fi Plug in your Orbit® B-hyve™ timer Once your B-hyve™ timer is plugged into the power source, it will automatically look to pair with your smart device. In the top left corner of the timer screen the “Wi-Fi” icon will begin a graduated blinking sequence. This indicates that your timer is ready to pair with a smart device.
Simple Controls Programming the timer You can set your timer up with the app. But, if you don’t have Wi-Fi or just want to make an adjustment while you are outside, you can do it at the timer. Timer changes will be reflected in the app, and app changes will be reflected at the timer. It allows the gardener who left their phone inside to run a manual cycle, or adjust programming as needed and keep dirty hands away from the phone.
Specifications Battery Specifications Timer requires a CR2032 Lithium battery (included) To remove, lift on the edge of the coin cell battery. (Illustration) DO NOT use a screwdriver or other metal object. Insert the new battery at an angle and press to click the battery into place. The plus (+) sign on the battery must face upwards. WARNING: Risk of Fire, Explosion, and Electric Shock. Replace battery with Hitachi Maxell Ltd, Type CR2032 only.
