Manual

Manual Text Booklet – Helix Plus Upgrade Kit – ENGLISH – 9
into the wheel disk using the included Phillips screwdriver tool. Insert a wheel disk Ⓧ into the
inside of each wheel, lining up the spokes and slots in the wheel disk. Insert the wheel disk cap
Ⓦ
on the outside of each wheel lining up the screw holes with the bosses on the wheel disk. Using
the included Phillips screwdriver tool, fully tighten the three mounting screws to secure the wheel
disks and caps to the rear wheels. Check your installation by shaking the rear wheel and ensuring
neither the disk nor the cap move or rattle.
⚠
WARNING
⚠
◦
Proper assembly is required. Check that leg connectors are properly installed and fasteners
are tight. Pull on leg connectors to confirm they are secure.
󱈧 Attaching the stroller frame leg connectors
⃞ Open one of the stroller frame leg connector
Ⓣ assemblies by removing the two Phillips screws
that are loosely threaded into the connector using the included Phillips screwdriver tool. Position
each leg connector against its corresponding rear stroller frame leg, so that the triangular Helix
SmartHub Attachment openings are on the inside of the rear leg
Ⓢ. Slide the open leg connector
over the rear leg and around the tie rod bolt Ⓤ.
⃞ Close the leg connector over the rear stroller frame leg. Using the Phillips screwdriver tool, fully
tighten the two mounting bolts to secure the connector in place. Check your installation by
twisting on the connector to ensure it does not move. Repeat with the other connector.
󱈩 Attaching the stroller basket
⃞ Insert the stroller basket handle
Ⓛ into the rail on the underside of the front SmartHub. You will
hear a CLICK when it locks in place.
⃞ To secure the front of the basket, insert one of the plastic handles
Ⓜ into the opening on the front
part of the stroller frame. Hold it in place while inserting the other plastic handle into the opening on
the other side of the stroller frame.