Product Instruction
Table Of Contents
- 1.Product hardware specification
- 2.Product picture
- 3. Introduction to the use of EMMC module
- 4.Introduction to the use of POE module
- 4.1Module Picture
- 4.2POE module support IEEE802.3af， IEEE802.3af is a n
- 4.3Complete the installation of the poe module on the
- 4.4How to use the zora E1 development board with poe
- A.Use a switch or router that supports the 802.11af
- B.You can transmit data and power through the networ
- C.The zora E1 development board is working properl
- 4.5
- 5.Zora E1 product usage scenario
- 6.Download of burning tools and firmware
- 8.Hardware data
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or different
operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult with module manufacturer
for the installation method in end system.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
2.7 Antennas
This radio transmitter FCCID: 2A2CL-ZORAE1has been approved by Federal Communications Commission to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Model
Type
Connector
Peak gain ( dBi )
2400-2483.5
MHz
5150-5250
MHz
5250-5350
MHz
5470-5725
MHz
5725-5850
MHz
2400-2483.5
MHz
External
Antenna
/
2.97dBi
/
/
/
/
5000-6000
MHz
External
Antenna
/
/
3.44dBi
/
/
3.44dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:2A2CL-ZORAE1".
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for the transmitter when the module is
installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for
the system such as Part 15 B.