V3 Update Manual

3. Connection diagram:
1 2 3
Sat 1
1 2 3
Sat 2
BND
THRO
AILE
ELEV
RUDD
GEAR
AUX1
AUX2
Receiver R620x-R1220x V3
Orange Program Card
USB
POWER
1. Rx
2. Tx
3. NC
4. VCC_T
5. GND
Signal Power GND
Install bind plug
between THRO
and ELEV
5VDC (From BEC or separate power supply )
GND
To PC
4. Firmware update procedure:
- Install Bind Plug between Throttle and Elevator pins on the receiver;
- Connect Program card and receiver according to the diagram above;
- Power Up receiver using external BEC or separate power supply. A red LED will start blinking on
the receiver indicating that the receiver is in firmware update mode;
- Connect Program Card to PC via USB cable;
If all connections are correct Program Card will display following window: