User Manual (EU Version)

Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
Down and up Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Set up – Turn the Roller button to set the time in min. and sec.
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down
Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
a. Use the wheel to change the status of the switch then press the wheel.
b. Use the wheel to change the reset switch then press the wheel.
c. Use the wheel to change the status of the switch then press the wheel.
d. Press and hold the wheel to save an exit, or press the cancel key to exit without saving.
Setup:
1. Select “Throttle Curve” in main menu
2. Press the Roller button to select point L, 1, 2, 3, H.
3. Move the wheel left or right to change the point’s value (position) on the graph.
4. Press and hold the wheel to save an exit
5. Or press the cancel key to exit without saving.
Setup:
1. Select “Throttle Cut” in main menu
2. Press the Roller button to select the minimum throttle value or Sw (Switches 1 to 8 or Disable)
3. Move the Roller button left or right to change the value OR select the Switches
4. Press and hold the wheel to save an exit
5. Or press the cancel key to exit without saving.
9
6 CHANNEL TRANSMITTER
DIGITAL PROPORTIONAL RADIO
CONTROL SYSTEMPROGRAMABLE SYSTEM
Mode - Turn the Roller button to select a mode (Up, Down, Down then up)
Up Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down
Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
Down Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Set up – Turn the Roller button to set the time in min. and sec.
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down
Throttle cut
The throttle cut function is used for gas powered engines. When the chosen switch is toggled the
throttle will drop below the set minimum in order to cut the engine.