User Manual (EU Version)
Setup:
1. Press the Roller button to select channel
2. The right-side value represents high limit / The left-side value represents low limit. Move the
stick to the desired low or high value
3. Move the Roller button left or right to change the value.
4. Press and hold the wheel to save an exit
5. Or press the cancel key to exit without saving.
Setup:
1. Press the Roller button to select channel.
2. Move the Roller button left or right to change the subtrim’s value.
3. Press and hold the wheel to save an exit
4. Or press the cancel key to exit without saving.
7
6 CHANNEL TRANSMITTER
DIGITAL PROPORTIONAL RADIO
CONTROL SYSTEMPROGRAMABLE SYSTEM
End points
End points controls the low and high travel limits for each servo. For each channel the user can set
the low and high limits. This ensures that the channel date for the servo is consistent with structur-
al design and performance requirements to ensure the best results. Adjustment can be made for
any channel.
Subtrim
Subtrim controls the structure and angle different of each channel on the servo. It individually
adjusts the center position of each servo of the 6 channels. This is particularly useful when the
servo mechanics can’t allow very fine tuning.
Point to high value Point to low value