User Manual (EU Version)

Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
Down and up Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Set up – Turn the Roller button to set the time in min. and sec.
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down
Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
a. Use the wheel to change the status of the switch then press the wheel.
b. Use the wheel to change the reset switch then press the wheel.
c. Use the wheel to change the status of the switch then press the wheel.
d. Press and hold the wheel to save an exit, or press the cancel key to exit without saving.
Mixes
This function is used to create a mix between channels. For example, if at low throttle some auto-
mated flap movement is desired, it is possible to create a mix to do this. The difference between
curve mixes and linear mixes is that it is no possible to create a nonlinear relationship between the
master and slave.
Range test
This function temporarily reduces the transmitter’s transmission power to allow for a manageable
range test. Instead of having to walk several hundred meters away from the receiver, press and
hold the bind key and walk 30 meters away from your model for some effects.
Set up:
1. Select the “Range Test” in Main Menu
Setup:
1. Select “Mixes” in main menu
2. Press the roller button to select below options
Mix# 1 to 6
Mix is – on / off
Master – Channel 1 to 6
Slave – Channel 1 to 6
Pos. Mix - -100% to 100%
Neg. Mix - -100% to 100%
Offset - -50% to 50%
3. Move Roller button left or right to change the value of options
4. Press and hold the wheel to save an exit,
5. Or press the cancel key to exit without saving
10
6 CHANNEL TRANSMITTER
DIGITAL PROPORTIONAL RADIO
CONTROL SYSTEMPROGRAMABLE SYSTEM
Mode - Turn the Roller button to select a mode (Up, Down, Down then up)
Up Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down
Reset Switch – Turn the Roller Button to reset the switch 1 to 8 or None to position up, mid or
down
Press and hold the Roller button to save an exit
or press the cancel key to exit without saving
Down Mode:
Timer State – Turn the Roller button to select “Stop” or “Run”. If “Run” is selected, the timer is
counted up
Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button
Set up – Turn the Roller button to set the time in min. and sec.
Enable Switch – Turn the Roller Button to enable the switch 1 to 8 or None to position up, mid
or down