User Manual

So now I add the Bind Plug to the Bind slot on the Receiver:
It looks now like on the right side.
It maybe also possible to do that
completly seperatly from the
receiver with another power
source – I use the receiver for the
power and I didn't test it yet else.
Now keep the bind „hidden“ button of the orange pressed when you enpower the system.
They should both blink now...
Start the bind process usual with your transmitter (press bind on startup in my case) and the display
also shows up that telemetry was found!
When it' binded (you will notice that with the LEDs)
power off the receiver again and unplug the bind plug
from it.
When you enpower then the receiver
again it should find the transmitter –
so it seems to work:
Lets check:
I also ordered the temperature and
Voltage sensor and plugged it in the
orange and the voltage sensor in here
for testing 3S LiPo.
The Telemetry screen of our Transmitter should show now the current temperature at the sensor and