User Manual

How to BIND the orange telemetry module:
First of all make sure to BIND your receiver to your
radio.
If already bound then insert the BIND plug in the
BIND port. The tricky part is now to connect your
battery, while pressing the BIND button the orange
telemetry module at the same time.
The receiver and the orange telemetry module
should now blink -
Start a “normal” BIND process with your transmitter
(pressing the bind button while power it on) and the
display should show that telemetry was found!
When BIND is complete power off the receiver and remove the bind plug. You can now
go ahead and move the orange telemetry module cable from GEAR to BIND port, if
you need the GEAR port for something else.
Every time you turn on your
radio you should see your
receiver and orange telemetry
module turn on and be bound to
your radio.
Remember to order the
temperature and voltage sensor
harness. Plug in the harness to
the port called Temp/Vbat
The Telemetry screen of our Transmitter should now
show the current temperature at the sensor and the
voltage of the battery – Else you need to enable
telemetry on your radio.