User Manual

10/12/13 The RX3S Orange 3-Axis Flight Stabilizer V2
www.bungymania.com/fpv_immersion/rx3s_orange_v2.php?SELECT=rx3s_orange_v2&TITREPAGE=Le RX3S Orange 3-Axis Flight Stabilizer V2 3/4
E as y ins tallation with V elc ro RX3 S here on Bixler 2 . Roll c orrec tion on the right wing.
Operation RX3S. The RX3S does not need specific power. Once you connect your drive battery will be powered by the receiver (red LED) and
correct the deviations of trajectories on three axes. As you can see from the photos, the rudders are in opposition to bring the unit back on course.
They involved a short time (before returning to neutral) and even stronger than the gain. This can not be exaggerated corrections and did not
induce oscillatory behavior in flight. The correction is repeated as many times as needed with a frequency related to the required gain.
O nc e you c onnec t your battery propus ion it will be powered by the rec eiver (red LED ) and correc t the deviations of trajec tories on three axes .
H ere c orrec tion on the depth and on the fins .
Adjusting the gyro gain is due to the potentiometers. Preset to 50% for soft stabilization, they are adjustable (up or down) for each channel to
get the desired response.
- YAW (Yaw): vertical axis.
- PITCH (pitch): transverse axis.
- ROLL (roll ). longitudinal axis
Be the first flight with these settings, set at altitude safety and enable the stabilizer. Observe the behavior of the device on its three axes. Ask and
increase the gain on the ways that needs it. Beware, if the gain is too high, the device becomes uncontrollable. It must then disengage the
stabilizer to regain control. Ask the unit and adjust the settings. A good compromise is found when maximum stabilization effect is achieved without
oscillatory phenomena or loss of control.
P otentiometers allow adjus tment of the gyro gain. Remote O N / O FF: it c an be enabled or dis abled from an international flight.
4 - Conclusions: The electronic control between more in our devices. Lower prices and miniaturization have dropped the latest barriers to its use.
With a very low selling price ($ 18) and relative ease of use, RX3S is a valuable aid in steering.
What are these applications? Beginners can draw some benefit with soft settings. It makes the hand launching, landing and windy, it helps reduce
the effect of wind gusts pop. It also automatically compensate the action pull-up shutters. Lovers of aerial photographs and the FPV apprécireont
because it helps keep the straighter and a constant altitude.
Is it easy to install? Yes very easy so it is small, only multiple connectors required may pose problems on very small devices.
Is it easy to adjust? Fairly easy to adjust thanks to the knobs but it requires extensive testing where to put the device each time. Each channel
further requires a special setting in relation to the surface of the c ontrol surface.
Is it effective? Quite effective when properly adjusted. It is totally transparent to the orders of the rubber sleeves and larger deviations of
trajectories. But this is not an autopilot and stabilization is not perfect. You can not put the radio or texting or go get a coffee ... The adjustment
range seems quite satisfactory gains without any time to be extensive (fine tuning).
There are risks? Yes there is a risk of losing control of the airc raft when the gains are too large. Hence the need to take time to proceed
gradually, care settings and must be used to disengage the inter action of the stabilizer to regain control of the aircraft in case of problems.