User Manual

10/12/13 The RX3S Orange 3-Axis Flight Stabilizer V2
www.bungymania.com/fpv_immersion/rx3s_orange_v2.php?SELECT=rx3s_orange_v2&TITREPAGE=Le RX3S Orange 3-Axis Flight Stabilizer V2 2/4
T he gain, inverters trac ks , inputs and outputs .
Inputs (input) from the receiver are marked with:
- AIL. aileron input
- ELE: depth entry.
- RUDD: steering input.
- TO:. input control on / off stabilizer (in the gyro to "reverse")
It must connect the receiver channels to the inputs of RX3S using connectors to male / male: 10CM Male to Male Servo Lead . For security, add a
connector on the auxiliary (AUX) input to disable the stabilizer from a cross. I advise you to manage your connections because there will be many
extensions at the end of the operation.
Y ou mus t c onnec t the rec eiver channels to input RX3 S us ing c onnec tor / male male.
The outputs (output) to the servos are marked by:
- AIL-L: left aileron servo output.
- ELEV: servo output depth.
- RUDD:. steering servo output
- AIL-R: right aileron servo output.
Similarly so you must connect the outputs of the RX3S servos control surfaces (just like a receiver). You have 2 outputs for fins, but depending on
your configuration you may need to use a single (with a Y).
To use a Delta or V-tail mixer simply switch the corresponding switch. On your radio useless select the same mix, the RX3S that support. The radio
must be set to a normal aircraft program.
Y ou have 2 outputs for fins , but depending on your c onfiguration you may need to us e a s ingle (with a Y ). .
3 - Installation, adjustment and operation of RX3S: The RX3S is easy to use. It is small and light, quickly found its place in the body and has
little impac t on the flying qualities of the aircraft (wing loading). Follow a few basic rules.
How to install RX3S? Install RX3S in the body to a location with low (not before the battery ;) Here are some tips:
- as close as possible to the receiver. You can minimize the size of the connectors (extension male / male 10cm for example).
- as far as the motor / controller pair out of the main source of noise.
- horizontal as possible to ease the adjustments and corrections gyro.
- attach a vibration support (velcro, hard foam ..).
- Be sure to keep easy access to potentiometers for not having to disassemble everything each time you want to change the gain.
Remote ON / OFF: The stabilizer can be activated or deactivated in flight. You just have to connect the AUX input on your radio channel that you
can activate with a cross. It should also switch the first switch (AUX CTRL | GYRO) left. You will be able to take off without the assistance of rx3s
then activate the air once or reverse.