User Manual

10/12/13 The RX3S Orange 3-Axis Flight Stabilizer V2
www.bungymania.com/fpv_immersion/rx3s_orange_v2.php?SELECT=rx3s_orange_v2&TITREPAGE=Le RX3S Orange 3-Axis Flight Stabilizer V2 1/4
The RX3S Orange 3-Axis Flight Stabilizer V2.
[8 655 hits - 2 15 votes ]
By Bernard C hevalier, Franc e (February 2 01 3 ). T rans lation
It works by automatic
corrections and combined routes aileron, elevator and rudder. Thus any change unwanted path due to wind or any other factor, is
countered immediately. The flight became more stable, allows boarding of new applications (aerial photography, FPV flight ...).
T he RX 3S O range 3- A xis Flight Stabilizer V 2
1 - Specifications RX3S.
2 - How to connect RX3S.
3 - Installation, adjustment and operation of RX3S.
4 - Conclusions.
5 - Summary: Pros and cons.
6 - links.
1 - Specifications RX3S: Equipped with a gyro type gyro3-axis MEMS RX3S acts on the 3-axis flight control: roll (aileron), pitch (depth) and yaw
(direction) to stabilize the flight of an aircraft . radio controlled fixed wing
Its application areas are very diverse and varied: piloting assistance for beginners (hand launch, landing ..), the trajectory correction in the wind,
the course keeping in fpv, the stabilization aerial view taken from ...
Version 2 of RX3S has been marketed since late 2012 for $ 18. On a much smaller than the V1 (saving) size this new version offers features like a
very valuable On / Off control from a releasable AUX flight and mixing control surface for Delta (Lift up) equipment or V- tail (V stabilizers for
gliders).
T he RX 3S O range 3- A xis Flight Stabilizer V 2 .
Features :
Flight stabilization on any fixed-wing aircraft (including V-tail/Delta models).
Remote ON / OFF: it can be turned on or off in flight via an AUX channel.
Supports 3D flight without compromising stability.
Independent adjustment of the gyro gain potentiometers for aileron, elevator and rudder.
Reversals in direction of servo by switches accessible from the front of the module.
Compact and lightweight design. Features :
Size: 44x26x14mm
Weight: 10g
IC: ATMEGA168PA
Gyro 3-Axis MEMS
Input Voltage: 4.8-6.0V
Signal from Receiver: 1520us
Signal to Power: 1520us
Manual: no.
Available in HK: RX3S OrangeRx V2 .
Essential accessory: 10CM Male to Male Servo Lead .
2 - How to connect RX3S: RX3S The module is very easy to use. It takes place between the receiver and servos. He did not need to separate
(unlike V1) supply. The "S" at the bottom of the module (see photo) shows the signal and allows to properly guide your connectors do not have
keyed. We can reverse the direction of operation of the switch through different channels (RUDD, AIL, ELE ...). The potentomètres used to adjust
the gain separately on the three channels.
The RX3S OrangeRx V2 is a flight stabilizer running on three axes and suitable for any fixed-wing aircraft.
Original text
Le RX3S OrangeRX V2 est un stabilisateur de vol fonctionnant sur 3
axes et adaptable sur n'importe quel avion à voilure fixe.
Contribute a better translation

Summary of content (4 pages)