User Manual

Setup:
I recommend connecting up the system prior to gyro mounting to verify it is functioning
properly.
Connections:
Wire the Rx to the Stabilizer as follows:
1) Use Male to Male cables purchased separately.
2) Orient the Brown or Black lead of the cable to the outside edge of the board
(shown as – on picture above) and the yellow or white lead towards the inside
(shown as S on picture above).
3) Connect the Yellow AIL Input of the Stabilizer to the Aileron output of Rx
4) Connect the Yellow ELE Input of the Stabilizer to the Elevator output of the Rx
5) Connect the Yellow RUD Input of the Stabilizer to the Rudder output of the Rx
Wire the Servos to the Stabilizer as follows:
1) If you have 1 Aileron servo or 2 Aileron servos on a Y connector, connect to the
Gray Ail[L] output of the Stabilizer. If you have 2 Aileron servos that are
reversed from each other (connected on 2 separate channels in your TX, Mixed
and reversed from each other), connect one to the Ail[L] and the other to the
Ail[R]. Note that you MUST double check the Transmitter reversing before
flight! Transmitter reversing is tested without moving airplane and ONLY moving
sticks.