User Manual

7) Choose your firmware
I tried the “openlrsngtx”, but couldn’t get transmitter to transmit afterwards.
So I chose to use flytron m2/m3. This worked fine.
8) Flash the firmware.
9) Click the connect button to flash the receiver, but…
I had to disconnect the GND lead on the tx and plug it into the taranis transmitter – USB doesn’t have the power
needed for the transmitter.
I could only flash the receiver by following this procedure.
a) Have a battery and an ESC ready and plugged into the RX channel 1. Black or brown to the outside. DO
NOT PLUG IN BATTERY YET.
b) Make sure configurator is open, USB is unplugged, and radio is off.
c) Plug in USB (configurator should connect automatically), wait about 5 seconds, turn on Taranis, when blue
light starts blinking plug in RX battery.
The Taranis blue light will become solid and the lights will change on the receiver.
d) Click on rx tab in configurator.
e) If the default settings are fine, save to rx.
If you have another receiver do this same procedure with that one. NOTE: It is very important to follow ‘c’
above in the exact order.
Disconnect everything and bind the receiver to your transmitter – Turn on transmitter, press black button in JR
Module for a few seconds and release. When binding is complete turn transmitter on and off again.
You are done