User Manual

AUX - PWM auxiliary output.
Red and Orange LED Indications
During binding procedure:
Orange LED is blinking rapidly. After receiving binding signal from the transmitter
blinks slowly for several seconds and then becomes solid if
connection is correct.
In normal operation
In presence of transmitter signal: Orange LED is solid. If the transmitter signal is
lost Orange LED is OFF.
Red LED blinks number of holds(up to 256) – signal losses with more than 1
second when receiver had to trigger a fail safe event. The LED will
flash the number of holds then pause (e.g., flash, flash, flash, pause, flash, flash,
flash, pause indicates three holds occurred since the receiver
was last turned on). Note that holds are reset to zero when the receiver is turned
off. During the first rides it’s recommended to check the red
LED hold indicator. If it’s flashing, it’s important to optimize the installation (move
or reposition antenna) until no hold occurs. On later flights, the
LED Hold Indicator can be used to confirm RF link performance.
Powering receiver with a battery