User Manual

ManualsBrandsOrange ManualsHobbyOrangeRx Futaba FASST Compatible 8Ch 2.4Ghz Receiver

Instruction Manual for TFR8-S

Introduction

1.1 Compatibility:

FASST 2.4G: Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode)

the Receiver TF Modules: TF-8M, TF-14M

1.2 Specifications:

Operating Voltage Range: 3.5V~10V

7ms (HS)

2. Setup

2.1 Bind procedure:

Turn on the transmitter, connect the battery to the receiver while pressing receiver’s F/S button. After the

RED LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating

normally.

2.2 Setting failsafe:

TFR8-S supports failsafe function for all channels. Follow the steps below to set failsafe:

1) Bind the receiver first, and disable failsafe on the transmitter side;

2) Set all transmitter controls to the desired failsafe position;

3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating

the failsafe is set up successfully.

If you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.

Warning: Some transmitter manufacturers use a failsafe method that can interfere

with that used by the Receiver. Be sure to disable any transmitter failsafe

settings before setting the Receiver failsafe positions. Unusual jitter may result

otherwise.

2.3 LED Status:

3. How to switch between two PPM modes

Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6

seconds and then release. The red LED will flash fast in HS Mode and slow in FS Mode. Repeat this to

alternate modes.

Warning: HS Mode is only applied for high-speed digital servos. Other servos

should select FS Mode, otherwise servos will get hot or even burn out.

RED LED GREEN LED Mode

Off On Normal mode

On On Waiting to be bound

Flashing On Signal lost

On Flashing twice Set failsafe

Flashing slowly On FS mode

Flashing fast On HS mode

Instruction Manual for TFR8-S

4. How to create a ganged, multi-channel receiver

TFR8-S can be paralleled with a TFR8/TFR8-S to become a multi-channel FASST

compatible receiver.

Follow the steps below:

1) Bind both receivers to the transmitter/transmitter module;

2) Connect CH1 & CH2 of TFR8-S by a jumper, then CH3 will be shifted to CH9, CH4 will be shifted

to CH10, and so forth;

3) The two receivers can be placed in different areas of the model.

1.3 Features:

1) Compatible with FASST 2.4G: Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode);

2) Parallel with TFR8/TFR8-S to become a 14 channel FASST compatible receiver;

3) Improve capability of anti-interference;

4) Firmware upgradable

Dimension: 55*33*14mm

Weight: 14.2g

Latency: 14ms (FS)