User Manual

Technical requirements

for Universal module – substitute or in parallel of Orange Module 9171000070

The module is used in JR- compatible module transmitters with DSM2/DSMx receivers.

In addition to manual selection there will be an automatic selection option. This mode will be

selected based on the best protocol available in the receiver.

Connection to transmitter - Standard JR compatible 5-pin connection

Input – PPM, 5V

Output protocols:

DSM2 –1024/22ms, 2048/11ms

DSMx – 22ms/11ms

Walkera Devo

Output power: switch selectable, 4 levels:

–

10mW

–

25mW

–

50mW

–

100mW

The module will have a 8 position SPST DIP switch for manual protocol and options selection.

Following features assigned to the switch:

SW1:

Walkera/DSM2(x) protocol selection. ON-Walkera, OFF-DSM2(x). In Walkera mode SW3..SW6 are

ignored.

SW2:

Channel mapping. ON-AETR, OFF-TAER

SW3:

DSM2(x) Auto/Manual mode – selects manual and automatic settings for DSM2(x). ON-Auto mode,

OFF-Manual mode

SW4:

DSM2/DSMx. ON-DSM2, OFF-DSMx. Switch position will be ignored in auto mode(when SW3 is ON)

SW 5:

11ms/22ms for DSM2 and DSMx. ON-11ms, OFF-22ms. Switch position will be ignored in auto

mode(when SW3 is ON)

SW6:

1024/2048 for DSM2 only. Switch position will be ignored in auto mode(when SW3 is ON)

LED: Green, multiple functionality depending on mode used

DSM2, 1024 mode – OFF

DSM2, 2048 mode – single blinks

DSMx, 22ms mode – double blinks

DSMx, 11ms mode – triple blinks

Buzzer: multiple functionality depending on mode used

PAGE 1
Technical requirements for Universal module – substitute or in parallel of Orange Module 9171000070 The module is used in JR- compatible module transmitters with DSM2/DSMx receivers. In addition to manual selection there will be an automatic selection option. This mode will be selected based on the best protocol available in the receiver.
PAGE 2
When powered on in presence of PPM signal produces three short beeps During binding procedure: – successful binding - three short beeps – unsuccessful binding – single long beep During range test – continuous short beeps once every second. Connector P1: PIN1- PPM signal, TTL 5V PIN2- Not connected, PIN3- VCC In, 6-18VDC, 100mA PIN4- GND PIN5- for future use Button 1(ID) – In Spectrum mode: when pressed upon power on a new unique ID is assigned to Tx. Totally 4 billion combinations available.