User Manual

successful. If the bind was unsuccessful it generates one long beep. After binding procedure is over the module enters the
regular transmitting mode and stays in this mode until power turned off.
ID change:
When powered up with Button1 pressed the new ID will be generated. The new ID wil be generated regardless if PPM signal
present or not. After detection of Button 1 pressed module waits for 3 sec then generated a new ID and buzzer makes long
beep(0.3 sec). After this the module waits until the button 1 is released. When button is released the module detects PPM
signal from the radio. After ID changing following binding procedure is necessary.