User Manual
combinations available. You may want to change ID before binding to another model to make sure that if you accidently turned previous model
ON with settings for the new model, the previous one will not respond to your radio transmitter.
R
ANGE
T
ESTING
Before each flying session and especially with a new model, it is important to perform a range check.
Make sure that your transmitter battery is fully charged. Be careful and make sure that all propellers on your aircraft are removed.
Turn your transmitter on and following turn on your receiver.
Make sure that the orange LED on your receiver/satellites is ON and solid. That indicates a good signal received.
Move the sticks and confirm that all servos/control surfaces are moving smooth and without stopping and delays. Ask your buddy to watch your
aircraft.
Move 30 steps away (appr. 28 meters). Press and hold BIND button. Move sticks and check if all servos are moving smooth and without
delays. Check if orange LED on the receiver is solid ON.
If orange LED is solid ON and all control surfaces move smooth and no delays then the range test is PASSED.
C
ONNECTORS
:
Connector P1 Pin description:
PIN1- PPM signal, TTL 5V, 6-12 channels
PIN2- Not connected,
PIN3- VCC In, 6-18VDC, 100mA
PIN4- GND
PIN5- for future use
Antenna connector:
SMA connector to attach a standard rubber duck 2.4GHz 50Ohm antenna.
B
UTTONS
:
Button 1(ID)
Both Spectrum and Walkera modes:
When pressed upon power on a new unique ID is assigned to Tx.
There is totally 4 billion combinations available. When powered up with Button1 pressed the new ID will be generated. The procedure
of new ID generation is initiated regardless if PPM signal present or not. After detection of Button 1 pressed module waits for 3 sec
then generated a new ID and buzzer generates long beep (0.3 sec). After this the module waits until the button 1 is released. When
button is released the module detects PPM signal from the radio. In Wakera mode as soon as PPM signal is detected the module
enters binding mode and following standard transmission mode. In Spektrum mode following binding procedure is necessary.
Button 2(Bind)
In Spectrum mode:
When the module is powered on while the button is pressed a binding procedure is initiated.
When pressed during operation the output power is reduced to 1mW for a range check
In Walkera mode:
When pressed during operation the output power is reduced 1mW for a range check. Pressing button upon power ON in this mode
doesn’t have any function assigned.
S
WITCHES
:
SW1: Walkera/DSM2(x) protocol selection.
ON-Walkera,
OFF-DSM2(x)
Note: In Walkera mode SW3..SW6 are ignored.
SW2: Channel mapping.
ON-AETR
OFF-TAER
SW3: DSM2(x) Auto/Manual settings for DSM2(x).
OFF-Auto mode
ON-Manual mode
SW4: DSM2/DSMx. Selects DSM2/DSMx protocols in manual mode
OFF-DSM2
ON-DSMx
Note: Switch position will be ignored in Auto mode(when SW3 is ON)
SW5: 11ms/22ms for DSM2 and DSMx
ON-11ms
OFF-22ms
Note: Switch position will be ignored in Auto mode(when SW3 is ON)
SW6: 1024/2048 for DSM2 only.
OFF-1024