User Manual

===9xr pro+ OrangeRX Internal module===
*************************************************************************************
This manual is for using of Turnigy 9xr pro+ OrangeRX Internal module with telemetry.
Explaining How to set transmitter 9XRpro.
Module, you can get from HobbyKing.com
OrangeRX 2.4Ghz Telemetry Module For Turnigy 9XR Pro (DSMX/DSM2/Walkera Compatible)
If your transmitter do not work, see & set my way.
Then, you can get the way "How to Use"
2017.01.21
Prepared by Hyoung-Jin An
Busan Chang Gong, Culb, Korea
************************************************************************************
<1> To use this module in a 9XR-PRO, set the protocol to "DSM2" (it does DSMX as well),
<1> and select the type as "9XR-DSM".
<2> Make sure the telemetry is set to COM1
<2> and "Invert COM1 is ON". This is done in the Telemetry menu.
<3> Binding is done at power on, either by holding the button on the back of the module in,
<3> or the trainer switch pulled forwards.
<3> Keep the switch held or the button pressed until bind completes
Now here, Setting Method on the menu From "Factory Default"
--------------------------------
<1> SETTING "PROTO" & "DSM TYPE"
--------------------------------
Model sel >> Setup
On the 1st menu ("Setup 03" 1/13)
...
...down& down
...
Default Sw TRE012AG
Volume Control ---
Beep Cnt RETA123
Proto PPM 8CH 300uSec <==HERE!!!
PPM FrLen 22.5mSec <==HERE!!!
PPM 1st Chan 1
▽▽ Setting Marked "HERE!!!"
...
Beep Cnt RETA123
Proto DSM2 RxNum 10 <== Set "Proto" to "DSM2"
DSM Type 9XR-DSM <== Set "DSM Type" to "9XR-DSM"
PPM 1st Chan 1
...