CRUSH PRO SERIES OWNERS MANUAL CR60C, CR120C & CR120H 4
THANK YOU! Thank you for choosing Orange. You are now a member of the ‘Legendary British Guitar Amplifier’ owners club! Since 1968 when the company was founded, Orange has been a pioneering force in the guitar amplification industry. Today, with a team of the world’s finest amplifier engineers, Orange continues to push back the boundaries of conventional amplifier design.
CONTENTS CONTACT DETAILS ................................................................................................................................... 4 IMPORTANT SAFETY INFORMATION ....................................................................................................... 5 EMI .......................................................................................................................................................... 7 BEFORE USING YOUR AMPLIFIER .............................
CONTACT DETAILS Orange Amplification OMEC House 108 Ripon Way Borehamwood Hertfordshire WD6 2JA ENGLAND Tel: +44 20 8905 2828 Fax: +44 20 8905 2868 info@omec.com Orange USA 1741 Wilwat Drive Suite A1 Norcross GA 30093 USA Tel: 1-404-303-8196 Fax: 1-404-303-7176 Tel: 1-404-303-8196 Fax: 1-404-303-7176 info@orangeusa.
IMPORTANT SAFETY INFORMATION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated ‘dangerous voltage’ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades, one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
EMI To reduce the possibility of outside electrical interference during performance, operate your amplifier and instrument away from appliances/equipment that generate high levels of electronic/electromagnetic noise. This may include, but is not limited to: fluorescent lighting, refrigerators, motors, mobile phones, radios, computers etc. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2.
BEFORE USING YOUR AMPLIFIER Always ensure the correct speaker load (Ω) is connected to the SPEAKER OUTPUT terminal(s) at all times during operation. The speaker outputs are found on the rear of the amplifier and are wired in parallel. The minimum total load is 8Ω. Only connect cabinets as described below. Note: Never use instrument cable to make speaker connections. Use only quality, unshielded speaker cable.
FRONT PANEL FEATURES POWER: This switch turns on the mains power to the amplifier. INPUT: Plug your instrument into this jack socket. CHANNEL: This switches between CLEAN and DIRTY channels. MASTER VOLUME: Controls the overall volume of both CLEAN and DIRTY channels. MASTER REVERB: Controls the level of reverb applied to both CLEAN and DIRTY channels. The reverb type is selected using the toggle switch for either PLATE, HALL or SPRING.
VOLUME (Clean/Dirty Channel): This controls the volume of the corresponding channel. At higher VOLUME settings, the CLEAN channel will begin break up into natural overdrive for a more vintage ‘crunch’ tone. The overall volume can then be reduced by turning down the MASTER VOLUME control. BASS (Clean/Dirty Channel): This controls the low frequency response of the corresponding channel. Increasing the BASS produces deeper tones.
REAR PANEL FEATURES SPEAKER OUTPUTS (16 Ohm, 16 Ohm) Always ensure the correct speaker load is connected at all times during use. Please refer to “Using Your Amplifier” for correct speaker connections. FOOTSWITCH jack sockets Connect a latching footswitch, e.g. Orange FS-2, with a Tip/Sleeve (Mono T/S) instrument cable connection to remotely switch channel and/or engage the reverb. FX LOOP (Send and Return) Use the “Send” jack socket to go to the input of effects pedals such as delay, chorus, etc.
FREE EXTENDED WARRANTY OFFER Orange amplifiers are under warranty for one year subject to consumer protection laws in the country of purchase and distributor’s terms and conditions, an additional year can be added by registering. Speakers supplied with an Orange amp or purchased separately at our online store are covered for 90 days from the date of purchase. The warranty status of any Orange product is subject to its being used for its intended purpose in suitable conditions.
