Rockerverb 50/100 MKII Owners Manual Orange Amplifiers OMEC House 108 Ripon Way Borehamwood Hertfordshire WD6 2JA ENGLAND Tel: +44 20 8905 2828 Fax: +44 20 8905 2868 info@omec.com Orange USA 2065 Peachtree Industrial Ct. Suite 208 Atlanta, GA 30341 USA Tel: 1-404-303-8196 Fax: 1-404-303-7176 info@orangeusa.
Before Operating Read These Important Safety Instructions The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. Failure to heed the instructions will result in severe injury or death.
ROCKERVERB 50/100 MKII Owners Manual Contents Warnings ................................................................................................................................................................................................1 Introduction .........................................................................................................................................................................................2 Front and Rear Panel Explanations.............................
Please ensure your amplifier is switched to the correct voltage for your country. If unsure please consult your dealer. Front Panel CLEAN CHANNEL DIRTY CHANNEL REVERB POWER CHANNEL 1. OFF STANDBY DIRTY ON CLEAN 1 2 3 VOLUME 4 5 TREBLE MIDDLE 6 7 BASS GAIN 8 9 TREBLE MIDDLE 10 11 BASS VOLUME 12 13 INPUT 14 Power/Standby Switch Power up the amplifier by switching the power, off/standby/on switch to the standby position and then switch to on, after 2 minutes.
Using Your Amplifier IMPORTANT! 1. 2. Before connecting your amplifier to a power source, please check the following: Ensure your speaker cabinet is connected to the correct impedance speaker output socket, (see Rear Panel, item 2), using a good quality speaker cable. Do not use guitar leads. Ensure that the voltage selector switch is set to the correct mains voltage, (see Rear Panel, item 5).
WARNING VALVES AND FUSES CAN FAIL AT ANY TIME! From time to time output and preamp valves may fail. We suggest that output valves are changed at least once a year and that all class AB models (50 watts and above) will benefit from having the bias checked and adjusted. Bias checking must be carried out by a qualified engineer. Orange amps are protected from damage caused by valve failure and inconsistent mains voltage by various fuses. We recommend that Orange users have a set of spare valves and fuses.
