User's Manual

8 9
2.3 Pairing Your Sensor and Receiver
Now that your sensor and receiver are powered, your
sensor needs to be paired with your receiver before your
system will funcon.
Have the sensor and receiver nearby and ensure the
sensor is turned away from you.
Learn mode has a me-out feature aer 30 seconds of
inacvity. If you didn’t hear a beep conrming that your
melody was paired, repeat the pairing process and make
sure that your selected zone is sll ashing when you
acvate the sensor.
Watch the video:
www.guardlinesecurity.com/quickstart
2.4 Installing your Sensor
We recommend mounng the moon sensor at least 3 to
4  (1 m) above the ground on a sturdy, non-metal surface
(i.e. a wall, wooden post or tree) with the sensor eye
pointed straight out over the area you wish to cover (such
as up your driveway looking towards your house). This will
decrease or eliminate false alarms from small animals,
give you a longer area to pick up movement, and avoid
unwanted alarms from nearby lawns/roads.
Always test that your sensor is working in your desired
locaon before installing it. Avoid placing your sensor
in a locaon where sunlight will shine directly into the
sensor eye. Direct sunlight may cause false alarms and/or
damage to the PIR sensor.
NOTE
NOTE
Turn ON
To exit LEARN mode
turn the receiver OFF
then ON
Press and hold
LEARN/NEXT
Press MELODY to
choose your chime.
There are 32 melodies
to choose from
ZONE 1 will start to ash
Release LEARN/NEXT buon
Your receiver is now in LEARN mode
To pair with another Zone:
press and release LEARN/NEXT
unl the zone starts to ash
Once you hear a melody you would
like to use, WAVE your hand in
front of the sensor to acvate.
You will hear a BEEP
1 foot away
VOLUME up