User's Manual

6 7
2. Geng Started
The basic steps for installing and seng up your Guardline
alarm are:
2.1 Powering your Receiver
2.2 Powering your Sensor
2.3 Pairing your Sensor and Receiver
2.4 Installing your Sensor
2.1 Powering your Receiver
The main power source for the receiver is the included
12v/500mA AC/DC power adapter. Simply plug the adapter
into a wall outlet, then into the side of your receiver, near
Zone 1.
We also recommend pung backup baeries into your
receiver, to ensure you maintain coverage in the event of
a power outage.
To insert baeries into
your receiver, push up
with your thumbs just
below the Guardline
scker on the back of
the receiver.
Install 4 (four) x AAA
baeries and replace
the cover unl it snaps
into place.
The power indicator will be blue
when the receiver is powered by
the 12v adapter and it will turn red
when it is running on baeries.
A ashing red indicator light means
your receiver baeries are low and
should be changed immediately.
1. Remove the screws from the four corners of the sensor
to access the baery compartment.
BE CAREFUL! The screws are very small, don’t lose them.
2. Install 4 (four) AA
baeries, replace the
cover and secure the
screws.
Watch the video:
www.guardlinesecurity.com/open-receiver
2.2 Powering your Sensor
The sensor runs on four (4) AA baeries (not included)
and operates wirelessly at a maximum distance from the
receiver of 500  (150 m) for the GL2000 model, or 1/4
mile (400 m) for the GL5000 model.
To insert baeries into the remote sensor:
Power
indicator