User's Manual

26 27
6.3 Mulple Receiver Conicts
You may have receiver conicts if you are experiencing
interference with the sensors, if you have mulple receivers,
and/or if you have over 16 sensors with one or more using
the same signal code. You will need to manually change the
code in one or more of your sensor units.
To manually change the signal code:
1. Remove one (1) baery from the sensor.
2. Press and hold the Test buon.
3. While holding the test buon, re-insert the baery.
4. Connue holding the test buon unl the sensor LED
ashes ve mes. When the LED ashes ve mes, the
sensor has a new signal code to use with the receiver.
See Secon 2.3, “Pairing Your Sensor and Receiver” for
instrucons.
7. Accessories
7.1 GUARDLINE Extra Receiver for Driveway Alarm
Add-on Receiver compable with the Guardline Driveway
Alarm.
7.2 GUARDLINE Extra Sensor for Driveway Alarm
• Addional sensor compable with the Original
Guardline Driveway Alarm
• Add up to 4 sensors per zone (for a total of 16)
• Sensor has a 40  (12 m) detecon range
• Weather resistant and ready to withstand the
elements
• An unlimited number of receivers can be added